Uniden UBW2101 Manuel d'utilisateur télécharger pdf (Page 23)

FCC Compliance Information

Part 15 Compliance Statement

This device complies with Part 15 of the FCC

Rules. Operation is subjected to the following two

conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any

interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to

comply with limits for a Class B digital device,

pursuant to Part 15 of the FCC rules and ETSI

(EN) 300328. These limits are designed to

provide reasonable protection against harmful

interference in residential installations. This

equipment generates, uses, and can radiate radio

frequency energy, and if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause interference to radio or

television equipment reception, which can be

determined by turning the equipment o and

on, the user is encouraged to try to correct the

interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Move the equipment away from the receiver.

Plug the equipment into an outlet on a circuit

dierent from that to which the receiver is

connected.

Consult the dealer or an experienced radio/

television technician for additional suggestions.

►

CAUTION! Any changes or modifications to

this equipment not expressly approved by the

party responsible for compliance could void

your authority to operate the equipment.

RF Exposure Information

The antenna used for this transmitter must be

installed to provide a separation distance of at

least 20 cm (7.9”) from all persons and must not be

collocated or operating in conjunction with any

other antenna or transmitter.

IC Compliance Information

Radio Equipment Notice

The term “IC:” before the radio certication number

only signies that Industry Canada technical

specications were met. Operation is subject to the

following two conditions: (1) this device may not

cause interference, and (2) this device must accept

any interference, including interference that may

cause undesired operation of the device. “Privacy of

communications may not be ensured when using

this device”.

CE Compliance Information

Products with CE Marking comply with EMC

Directive (2004/108/EC); Low Voltage Directive

(73/23/EEC); R&TTE(1999/5/EC) issued by the

Commission of the European Community.

Compliance with these directives implies conformity

to the following European Norms:

EMC: EN 301 489

LVD: EN 60950

Radio: EN 300 328

►

1 2 ... 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Uniden UBW2101 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour appareils photo Uniden UBW2101