Setting Up a Scan
You can have the receiver automatically cycle through the enabled channels.
Open the menu, and scroll down to select 1.
Scan time
.
Use 2.
RIGHT
or
LEFT
to select the amount of time you want the receiver to stay on each camera.
Choose
5 seconds
,
10 seconds
,
15 seconds
, or
20 seconds
. To turn off the scan and stay on the
current channel, select
Off
. To set the receiver into quad display, select
Quad
(see Using Quad
Display on page 21).
Double-check the channel settings (3.
CAM1
through
CAM4
) to make sure the correct channels
are enabled.
The receiver stays on each camera channel for the selected number of seconds, then switches to
►
the next active channel.
The receiver starts the scan at the currently selected channel, then scans the remaining channels
►
in order.
The receiver will only scan channels that are enabled in the menu.
►
The receiver does not go into quad display during a scan. ►
If you press ► to manually switch channels, the receiver turns off the scan. Follow the
procedure above to turn it back on.
If... Try...
The display says
No Signal
when the receiver switches to a
particular channel.
Making sure there is a camera assigned the channel. ‑
Making sure the camera is in range of the receiver. ‑
Troubleshoot the camera assigned to that channel. ‑
The receiver won’t switch to a
particular channel.
Making sure the channel is enabled (set to ‑
On
in the
menu).
The receiver won’t scan
channels.
Making sure ‑
Scan Time
is not set to
Off
or
Quad
.
Making sure more than one channel is enabled. ‑
I can’t switch channels manually.
Making sure more than one channel is enabled. ‑
Making sure you are not in quad display. ‑
UWS1117 OM.indd 20 28/9/11 10:21:24 AM
Commentaires sur ces manuels