Uniden MC 1010 Manuel d'utilisateur télécharger pdf (Page 6)

Engine Noise Suppression

Interference from the impulse noise generated by the electrical systems of

engines is sometimes a problem with radios. The MC 1010 has been designed

to be essentially impervious to ignition impulse noise and alternator noise.

However, in some installations it may be necessary to take measures to

further reduce the effect of noise interference. All DC battery wires, antenna

lead, and accessory cables should be routed away from the engine and

engine compartment, and from power cabling carrying particularly high

currents.

In severe cases of impulse noise interference, it may be necessary to install a noise

suppression kit. Contact Uniden for more information.

Antenna Considerations

A variety of antennas is available from a number of quality suppliers. It is

recommended you draw upon the advice of Uniden in determining a suitable

antenna for your vessel and range requirements.

In general, communication range is increased by using a high-gain antenna

placed as high as possible above the water line. Antennas should be located

away from metal objects. Antennas should not have excessively long coaxial

feed cables.

Installing The MC 1010

After you have carefully considered the various factors affecting your choice of

location, position the radio (with the bracket, microphone, power cord, antenna

and any auxiliary cables installed) into the selected location to assure there is

no interference with the surrounding items. Mark the location of the mounting

bracket. Remove the bracket from the radio and use it as a template to mark

the holes to be drilled for the mounting hardware. Drill the holes and mount the

bracket with hardware compatible with the material of the mounting surface.

Connect the red wire of the supplied power cord to the positive (+) battery

supply. Connect the black wire of the power cord to ground. The power cord is

equipped with a fuse to protect the radio. Use only a Six (6) Ampere fast blow

fuse for replacement. Connect the power cord to the keyed connector on the

power “pigtail” (See page 9).

Connect the antenna and all other auxiliary cables and accessories.

Install the radio in the mounting bracket and connect all cables and

accessories to the appropriate jacks and connectors.

C:...MC 1010.vp

Thu Jan 28 14:42:51 1999

Color profile: Disabled

Composite Default screen

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Pas de commentaire

Uniden MC 1010 Manuel d'utilisateur Page 6