Uniden EXI2926 Manuel du propriétaire télécharger pdf (Page 23)

BASICS [ 21 ]

BASICS

•The tone feature only

applies when the dial

mode is set to pulse.

•This special number

can be stored in a

memory location. This

is referred to as Chain

Dialing.

note

Redial

The redial/p key redials the last number dialed. The redialed number can be up to

32 digits long.

HHaannddsseett

Press line 1 or line 2, then press redial/p.

Or press

redial/p, then press line 1 or line 2.

BBaassee

Press line 1 or line 2, then press redial/p.

If any key is pressed before, the last number will not redial.

Tone Dialing Switch-over

Some telephone companies use equipment that requires

pulse dialing (sometimes referred to as rotary dialing).

If you need to enter tone dialing digits, you can switch-over to tone dialing during

the call. For example, entering your bank account number after you have called

your bank.

Initially make your call with the pulse dialing mode. Once your call connects, press

/tone. Enter the desired number. These digits will be sent as tone dialing.

Once the call ends, the tone mode is canceled and pulse dialing mode resumes.

Traveling Out-of-Range

During a call, as you begin to move your handset too far from your base unit,

noise increases. If you pass the range limits of the base unit, your call will

terminate within 5 minutes.

The EXI2926 has two

independent last number

redial memories; one in

the handset, the other

in the base.

tip

EXI2926-ENG/03/07 3/7/02 1:47 PM Page 21

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Pas de commentaire

Uniden EXI2926 Manuel du propriétaire Page 23