Uniden EXI2926 Manuel du propriétaire Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 38
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
GETTING STARTED [ 11]
GETTING STARTED
1) Insert two mounting screws into the wall, (with their appropriate anchoring
device), 3-15/16 inches apart. Allow about 1/8 of an inch between the wall and
screwheads for mounting the phone.
2) Set the retainer clip if necessary.
3) Refer to steps 1 through 9 on page 10 to mount the telephone.
Setting Caller ID Options
There are three Caller ID setup options available; they are AutoTalk, CIDCW (Caller ID on Call Waiting), and Area
Code. See page 12 for Area Code setup instructions.
AutoTalk allows you to answer the phone without pressing line 1 or line 2.
If the phone rings when AutoTalk is on, simply remove the handset from the base and the phone automatically
answers the call. Or if the handset is not on the base, press any key to answer the call. If the phone rings when
AutoTalk is off, you must press line 1 or line 2 to answer the call.
CCaalllleerr IIDD oonn CCaallll WWaaiittiinngg ((CCIIDDCCWW))
performs the same as regular Caller ID on a call waiting number.
YYoouu mmuusstt
ssuubbssccrriibbee ttoo CCIIDDCCWW ffrroomm yyoouurr pphhoonnee ccoommppaannyy iinn oorrddeerr ttoo uussee tthhiiss ffeeaattuurree..
1 Auto Talk:Off
2 CIDCW :On
3 Area Code:
Caller ID Setup
1 Line 1
2 Line 2
To change your Caller ID options:.
1) When the phone is in the standby mode, press and hold
call id/hold until the Caller ID setting screen appears.
2) Press
up/int’com or dn
/conf to select "Line 1" or "Line 2".
3) Press sel/vol.
The following screen appears.
4) Press
up/int’com or dn
/conf to move the cursor to the selection that you would like to change. Press the
sel/vol key to toggle between "
On" and "Off". Press sel/vol. Use the number keypad to enter or change the
area code. Press sel/vol again.
5) After you have made your selections, press call id/hold or return the handset to the base.
EXI2926 ENG Resize 9/4/01 2:02 PM Page 11
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Commentaires sur ces manuels

Pas de commentaire