Uniden 2 Spécifications télécharger pdf (Page 56)

Precautions!

sure that installing the system does not disable your alarm equipment.

If you have questions about what will disable alarm equipment, contact

your telephone company or a qualied installer.

Radio interference

Radio interference may occasionally cause buzzing and

humming in your cordless handset, or clicking noises in the

base. This interference is caused by external sources such

as TV, refrigerator, vacuum cleaner, uorescent lighting, or

electrical storm. Your unit is NOT DEFECTIVE. If these noises

continue and are too distracting, please check around your

home to see what appliances may be causing the problem.

In addition, we recommend that the base not be plugged

into a circuit that also powers a major appliance because of

the potential for interference. In the unlikely event that you

consistently hear other voices or distracting transmissions on

your phone, you may be receiving radio signals from another

cordless telephone or other source of interference.

Finally, it should be noted that some cordless telephones

operate at frequencies that may cause interference to nearby

TVs and VCRs. To minimize or prevent such interference, the

base of the cordless telephone should not be placed near or on

top of a TV or VCR. If interference is experienced, moving the

cordless telephone farther away from the TV or VCR will often

reduce or eliminate the interference.

Cordless telephone privacy

Cordless telephones are radio devices. Communications

between the handset and base of your cordless telephone are

accomplished by means of radio waves which are broadcast

over the open airways. Because of the inherent physical

properties of radio waves, your communications can be

received by radio receiving devices other than your own

cordless telephone unit. Consequently, any communications

using your cordless telephone may not be private.

I.C. Notice

Terminal equipment

NOTICE: This equipment meets the applicable Industry

Canada Terminal Equipment Technical Specications. This is

conrmed by the registration number. The abbreviation, IC,

before the registration number signies that registration was

performed based on a Declaration of Conformity indicating that

Industry Canada technical specications were met. It does not

imply that Industry Canada approved the equipment.

NOTICE: The Ringer Equivalence Number (REN) for this

terminal equipment is marked on the equipment itself. The REN

assigned to each terminal equipment provides an indication

of the maximum number of terminals allowed to be connected

to a telephone interface. The termination on an interface may

consist of any combination of devices subject only to the

requirement that the sum of the Ringer Equivalence Numbers

of all the devices does not exceed ve.

Radio equipment

The term “IC:” before the radio certication number only signies

that Industry Canada technical specications were met.

Operation is subject to the following two conditions: (1) this

device may not cause interference, and (2) this device must

accept any interference, including interference that may cause

undesired operation of the device. “Privacy of communications

may not be ensured when using this telephone.”

1 2 ... 51 52 53 54 55 56 57 58 59 60

Commentaires sur ces manuels

Pas de commentaire

Uniden 2 Spécifications Page 56

Commentaires sur ces manuels

Produits connexes et manuels pour Téléphones Uniden 2