Uniden DCT646-2 Manuel du propriétaire télécharger pdf (Page 16)

[14] GETTING STARTED

www.uniden.com

C. Connect the base unit

1) Connect the AC adapter to the

DC IN 9V

jack and to

a standard 120V AC wall outlet.

2) Set the base on a desk or tabletop, and place the handset in the

base unit.

3) Raise the antenna to a vertical position.

4) Make sure that the

charge

LED illuminates.

If the LED does not illuminate, check to see that the AC adapter is

plugged in and the handset makes good contact with the base

charging contacts.

•Connect the AC adapter to a continuous power supply.

• Place the base unit close to the AC outlet so that you can

unplug the AC adapter easily.

• After installing the battery pack in the handset, charge your handset at least

15-20 hours

before plugging into the phone line

5) Once the handset battery pack is fully charged,

connect the telephone line cord to the

TEL LINE

jack

and to a telephone outlet.

If your telephone outlet isn't modular, contact

your telephone company for assistance.

•Use only the supplied

[AD-830] AC adapter.

Do not use any other

AC adapter.

•Place the power cord

so that it does not

create a trip hazard or

where it could

become chafed and

create a fire or

electrical hazard.

note

UP01321BA_0.book 14 ページ２００３年１０月２８日火曜日午後２時１９分

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Pas de commentaire

Uniden DCT646-2 Manuel du propriétaire Page 16