Uniden APCO 25 Manuel du propriétaire télécharger pdf (Page 111)

Using Tone-Out

110

Fire Tone-Out Introduction

Your scanner can be set to respond to fire tone-outs

that use standard two-tone sequential paging, short

one-tone paging, and long group tone paging. You can

save up to 10 settings. When you select a setting in

standby mode, the scanner also monitors for any

other setting that uses the same transmit frequency,

modulation, and attenuation settings.

You need tone-out setup information from the agency

you wish to monitor. Check with your local agency or

on-line resources.

The Fire Tone-Out feature is not used in

Australia or New Zealand.

Turn the scroll control to select the tone-out to

monitor. All tone-outs that have the same frequency,

modulation, and attenuation setting as the one you

select, are also monitored.

In standby mode, the display cycles through all

monitored tone-out settings. Regardless of the current

display, the scanner always alerts on any received

tone-out that matches a stored setting.

If you press while in standby mode, the

scanner temporarily exits the mode and you hear all

transmissions on that frequency. No alerts sound,

even if a tone-out matches one you have stored.

Press again to return to standby mode.

Scroll to select the tone-out (1 - 10) you want to

program, then press . Then you can scroll to

any of the following settings and press to select

and modify the selected settings:

Note:

HOLD

EYES

Setting Tone-Out Standby

Setting Up Tone-Out

Tone-Out for...

Tone-Out Standby

Tone-Out for ...

Tone-Out Setup

Using Tone-out

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 139 140

Pas de commentaire

Uniden APCO 25 Manuel du propriétaire Page 111