Uniden BCT8 Spécifications télécharger pdf (Page 23)

You will experience a slight in the conversations you hear as the scanner checks the

Priority channels. You can cancel the priority check and the interruptions in the

conversations by pressing

HOLD/RESUME to hold on the frequency.

Note: The Highway Warning Alert is inoperative while the scanner is on Hold.

Remember to press

HOLD/RESUME to return to normal priority-scan operation.

Priority channel cannot be changed, but you can lock-out priority channels using

L/O.

Priority channels have been pre-determined by the manufacturer as those Highway Patrol

frequencies most commonly used for mobile extenders and for car-to-car and aircraft-to-car

operations. Mobile extenders re-transmit every radio broadcast received on the patrol car

radio to the officer’s walkie-talkie at low-power. Every time any officer or dispatcher talks

(transmits), the signal is broadcast like a beacon at low-power whether or not the officer is

out of the car.

You can select Priority Scanning mode by pressing

PRI.

• Normal Priority Scan mode.

The scanner checks the Priority frequency every two seconds. “

PRI” will be displayed.

• Priority only mode.

To only monitor the priority frequencies, press and hold

PRI to select Priority Only. This

mode is especially recommended for the following states:

(Arizona) (Michigan)

(Delaware) (Oklahoma)

(Florida) (Wisconsin)

“

PRI” flashes when you select Priority Only Mode.

• Priority off mode

The scanner does not check the Priority frequency. “

PRI” will not displayed.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Pas de commentaire

Uniden BCT8 Spécifications Page 23