Uniden BCT8 Spécifications télécharger pdf (Page 50)

9. Use the keypad to enter a new Offset Channel, then press E.

Note: • You can only input within a range of 380-759.

• If the system is not tracking properly, you may need to

try a new Base Frequency or Offset Channel, or you

may be missing frequencies from the system.

• You can set up to three Base, Spacing and Offsets for Motorola VHF/UHF trunked

systems.

Toggling the Status Bit

On Type II trunking systems there is a method by which specialized types of communications

utilize unique talkgroup numbers. An emergency call will occur on a unique talkgroup from its

primary assignment, for example. Because the BCT8 defaults to Status-Bit ON mode, you

never need to worry about missing these transmissions. If you have programmed talkgroup

33264 into Scan List memory, for example, and there is an emergency call within the group,

you will hear it on 33264.

The only time you may wish to turn Status Bits OFF is if you're trying to figure out the proper

Fleet Map of a Type I trunking system.

1. Press and hold

TRUNK for 1.5 seconds and select the bank you want to change.

2. Use the

▲ or ▼ key to select (Motorola TYPE2 800MHz), (Motorola Type2

VHF) or (Motorola Type2 UHF), then press

3. Use the

▲ or ▼ key to select , then press E.

4. Use the

▲ or ▼ key to select or , then press E. The scanner returns to

Status Bit list item.

Control Channel Only Mode

When this function is activated, trunking is performed using Control Channel data only.

Voice channel (also known as "DATA channel") frequencies do not have to be programmed

into memory. This feature only applies to Motorola 800 MHz systems.

1. Press and hold

TRUNK for 1.5 seconds and select the bank you want to change.

2. Use the

▲ or ▼ key to select (Motorola Type2 800MHz) or (Motorola Type1

800 MHz), then press

3. Use the

▲ or ▼ key to select , then press E.

4. Use the

▲ or ▼ key to select a plan from 4 frequency plans,

then press

E. The scanner returns to Control Channel Only

list item.

Note: You must choose a plan before you begin to Control Channel Trunk (Only when 800

MHz system is selected).

When you deselect Control Channel only mode, appears on the display.

Read the descriptions of the Plan 1~4 for details on which may apply for you.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Uniden BCT8 Spécifications Page 50

Commentaires sur ces manuels

Produits connexes et manuels pour Les radios bidirectionnelles Uniden BCT8