Uniden BCT8 Spécifications télécharger pdf (Page 58)

If you experience difficulty while in TrunkTracker mode, try the following steps.

If you still cannot get satisfactory results while using your scanner or if you want additional

information, please call or write the Uniden Parts and Service Division. The address and

phone number is listed in the warranty at the end of this manual. If you would like immediate

assistance, please call Customer Service at (800)297-1023.

If you have internet access, you can visit

scanner.uniden.com for additional information.

Problem Suggestion

1. Missing the Data Frequency.

2. Change to a Type 1 Scanner setup.

Review Fleet Map Programming on page 45.

1. No IDs have been programmed.

2. The IDs you have stored are not active.

1. Adjust the squelch for Trunking mode - refer to page 29.

2. Missing the frequency used for the data channel.

Check your frequency list.

1. Change a Type 1 scanner setup.

Review Fleet Map Programming on page 44.

2. Try another Preset Fleet Map or Program your own Fleet Map.

3. Check to see that all of the system's frequencies have been entered.

1. May be a telephone interconnect call, which are intentionally blocked by

your scanner.

2. The ID on your display is not active.

1. Logical channel numbers (frequencies) for the system are not programmed

in the correct order. Check frequency resources and reprogram.

2. Not all frequencies for the system are programmed.

Check frequency resources.

Scanner won't track.

Scanner won't stop

during Scan List mode.

Scanner will not acquire

data channel.

Missing replies to

conversations.

Channel Activity

Indicators are flashing

but no sound is heard.

Scanner not tracking an

EDACS system properly.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Pas de commentaire

Uniden BCT8 Spécifications Page 58